South Carolina Steel Buildings

South Carolina Metal Buildings, Built for South Carolina Weather

Price Your South Carolina Building Now!

Let’s start with your building size

(this field is required)
(this field is required)
(this field is required)
(this field is required)
(this field is required)
(this field is required)
(this field is required)
(this field is required)

*By clicking “Get My Free Quote”, you agree to our Privacy Policy and Terms & Conditions and consent to receive calls and SMS messages from US Patriot Steel about your quote request and related follow-up. Message/data rates may apply. Message frequency varies. Reply STOP to opt out or HELP for help. Consent is not a condition of purchase.

0

Completed Projects

0

Happy Customers

0

Projects in Progress

0

New Orders This Week

0

Completed Projects

0

Happy Customers

0

Projects in Progress

0

New Orders This Week

Why Steel Works in South Carolina

Steel buildings work in South Carolina because each frame is engineered to its own county’s loads, and those loads split hard between the coast and the Upstate. We are a dealer based in Fort Lauderdale, Florida, selling pre-engineered steel building kits made from American steel since 2005, not one of the metal building manufacturers in South Carolina. Our metal buildings in SC ship with PE-stamped drawings for the site.

Wind enters the drawings as a design wind speed under ASCE 7, plus an exposure category for open or sheltered ground. Design speeds run highest near the ocean, for good reason: Hurricane Hugo came ashore at Sullivan’s Island around midnight on September 22, 1989, as a Category 4 storm.

Earthquake design carries real weight around Charleston, one of the most seismically active areas of the eastern United States. Snow is a light design load, seen more often in the Upstate than on the coast. Summers are hot and humid statewide; our guide to insulating a metal building covers vents and insulation.

The farm structure rule and the beachfront setback line are in the codes and permits section below.

South Carolina at a Glance

What We Engineer for:

1
Wind

Design wind speed and exposure category set per county under ASCE 7, highest along the coast

2
Hurricanes

Coastal frames are sized for hurricane-level design wind speeds; a rating, not a storm guarantee

3
Seismic

The Charleston area is one of the most seismically active in the eastern US; its seismic design category goes on the drawings

4
Flood Zones

Check the parcel on FEMA flood maps, and the beachfront setback line near the ocean, before ordering

5
Heat

Hot, humid summers statewide; plan insulation and ridge vents with the frame

Planning a custom steel building? We’ll design a solution that fits your project, space, and specific needs.

Our building experts are ready — request your free quote today!
Get a Free Custom Quote
US Patriot Steel

Building Codes and Permits in South Carolina

State building code

The Building Codes Council, part of the state Department of Labor, Licensing and Regulation, adopts one set of codes for all of South Carolina, and every county and city must enforce them. The 2021 South Carolina codes have applied since January 1, 2023, with loads from ASCE 7-16; the 2024 editions follow on January 1, 2027. Local changes are valid only with Council approval.

Who issues the permit

Your local building department issues it: the city inside its limits, the county on unincorporated land. We don’t pull the permit; we supply the PE-stamped drawings, load calculations and specifications your application needs.

Coastal wind and seismic engineering

Your drawings state the design wind speed, exposure category and seismic design category for the site, and the frame, bracing and anchor bolts are sized to those figures. A local contractor pours the foundation to our anchor bolt layout. The design criteria of your building department show whether the site lies in the wind-borne debris region, where glazed openings need impact protection.

Farm buildings, floodplains and the beachfront

Under S.C. Code §6-9-65, a county or city may not enforce the building code on a farm structure, such as a barn or shed used on the farm and not lived in, once the owner files a farm-use affidavit; a permit can still be required. Check the FEMA flood map, and expect state coastal permitting seaward of the beachfront setback line.

State building code

The Building Codes Council, part of the state Department of Labor, Licensing and Regulation, adopts one set of codes for all of South Carolina, and every county and city must enforce them. The 2021 South Carolina codes have applied since January 1, 2023, with loads from ASCE 7-16; the 2024 editions follow on January 1, 2027. Local changes are valid only with Council approval.

Who issues the permit

Your local building department issues it: the city inside its limits, the county on unincorporated land. We don’t pull the permit; we supply the PE-stamped drawings, load calculations and specifications your application needs.

Coastal wind and seismic engineering

Your drawings state the design wind speed, exposure category and seismic design category for the site, and the frame, bracing and anchor bolts are sized to those figures. A local contractor pours the foundation to our anchor bolt layout. The design criteria of your building department show whether the site lies in the wind-borne debris region, where glazed openings need impact protection.

Farm buildings, floodplains and the beachfront

Under S.C. Code §6-9-65, a county or city may not enforce the building code on a farm structure, such as a barn or shed used on the farm and not lived in, once the owner files a farm-use affidavit; a permit can still be required. Check the FEMA flood map, and expect state coastal permitting seaward of the beachfront setback line.

Looking for expert advice on your custom steel building? Our team will help you plan every detail with clarity and confidence!

Call our steel building professionals for free, no-obligation guidance.
Call Now: (888) 415-1576
US Patriot Steel

What a Steel Building Costs in South Carolina

A steel building in South Carolina is priced by its size, the engineering its site needs and its finish level. Location moves the engineering: a coastal county adds frame weight for wind and seismic detailing, and an Upstate lot usually adds less. Steel building kits for sale across South Carolina are quoted parcel by parcel.

Size and height

From 20×20 to 30×40: carports and two-car garages.

From 30×50 to 40×80: horse barns and equipment barns.

From 60×80 up: warehouses and covered riding arenas.

Local loads (South Carolina-specific)

The same 40×60 takes more steel in Charleston County, with coastal wind and the Charleston seismic zone, than in Greenville County in the Upstate. Always give us your county, and your flood zone if you know it.

Finish level

The $ tier is the bare kit: frame, roof and wall panels. Insulation, roll-up and walk doors or liner panels lift the quote to $$, and a finished interior toward $$$. Dollar ranges by size are in our metal building cost guide.

Size and height

From 20×20 to 30×40: carports and two-car garages.

From 30×50 to 40×80: horse barns and equipment barns.

From 60×80 up: warehouses and covered riding arenas.

Local loads (South Carolina-specific)

The same 40×60 takes more steel in Charleston County, with coastal wind and the Charleston seismic zone, than in Greenville County in the Upstate. Always give us your county, and your flood zone if you know it.

Finish level

The $ tier is the bare kit: frame, roof and wall panels. Insulation, roll-up and walk doors or liner panels lift the quote to $$, and a finished interior toward $$$. Dollar ranges by size are in our metal building cost guide.

South Carolina Cities We Deliver to

Delivery and installation is statewide. These cities have a dedicated page with local permitting detail.

If your city isn’t listed, we still deliver to it. Call (888) 415-1576 or use the quote form above.

How South Carolina Owners Use Steel Buildings by Region

Upstate (Greenville, Spartanburg, Anderson; the I-85 corridor)

The Upstate builds for industry. BMW builds SUVs at its plant in Greer, Michelin North America is headquartered in Greenville, and Inland Port Greer moves containers for both by rail to the Port of Charleston. Suppliers along I-85 order commercial metal buildings for stock and fabrication; for larger clear-span floors, see our metal warehouses.

See also: Metal office buildings · Metal buildings with lean-to

Midlands (Columbia, Aiken, Camden, Sumter)

Horses shape the Midlands. Aiken’s Horse District keeps its roads unpaved around the Aiken Training Track and the polo fields, and Camden hosts the Carolina Cup steeplechase at Springdale Race Course each spring. Farms around Sumter need cover for equipment and hay. Start with our horse barns and stables.

See also: Barn with living quarters · Metal hay barns

Pee Dee (Florence, Darlington, Dillon and Marion counties)

The Pee Dee is row-crop country. Clemson’s Pee Dee Research and Education Center in Florence runs cotton and corn trials, and the farms around it need tall bays for planters and sprayers plus dry storage after harvest. Between seasons, farm trucks and trailers sit under metal carports.

See also: Metal farm buildings · Tractor barns

Lowcountry (Charleston, Summerville, Beaufort; Charleston, Berkeley and Dorchester counties)

The Lowcountry works around the Port of Charleston. Boeing assembles 787 Dreamliners in North Charleston, and Volvo Cars builds vehicles in Ridgeville, Berkeley County. Metal buildings in Charleston, SC, are engineered for coastal wind and the local seismic zone. Suburbs in Berkeley and Dorchester counties add contractor yards and self-storage, plus a few metal building homes; see our metal storage unit kits.

See also: Residential metal buildings · Recreational steel buildings

Design Your Building Now
40×60 Equipment Barn

I needed room for our tractor and the attachments used around the property. We planned a straightforward layout with enough space to move between items. Keeping the tools nearby means I can handle small adjustments without going back to the house garage.

Wallace F.  Sumter, South Carolina

36×48 Horse Barn

We used the shell for a small horse barn and arranged the interior work separately. I wanted practical storage for daily supplies included in the plan. That kept the feed and tack from ending up in makeshift corners afterward.

Donna J.  Aiken, South Carolina

30×50 Workshop

I work on small engines and wanted a dedicated place for ongoing projects. The shop fits separate benches for dismantling and assembly. I can keep a job organized while waiting for parts without losing all the space for other work.

Ricky S.  Anderson, South Carolina

Frequently Asked Questions

Yes. South Carolina has one set of codes statewide, adopted by the Building Codes Council and enforced by every county and city, and we engineer to it. Your drawings name the edition your building department applies and carry the site’s wind and seismic data.

Yes, up to the design wind speed of your coastal county, and that figure is a rating, not a promise against every storm. Frame, bracing and anchor bolts are sized to it, and your inspector checks them on the drawings. More in our article on whether a barndominium can withstand a hurricane.

Usually yes: the city issues it inside its limits, the county on unincorporated land. A farm structure with a farm-use affidavit on file is exempt from code enforcement, but a permit can still be required. Flood zone and beachfront rules apply separately, so call your building department before you order.

Yes. The seismic design category is on every set of drawings we supply, set for your parcel. It matters most around Charleston, where the 1886 earthquake remains the most damaging in the eastern United States. Soil under the site changes the result too, so send the full address, not just a ZIP code.

Yes, we supply steel horse barns and covered riding arenas across South Carolina, from the Aiken training farms to Camden. A shedrow layout and a wide center aisle both work in steel, and ridge vents help through humid summers. Your crew or a local erector puts it up; if you want installation arranged, ask when you request your quote.